get the electrics sorted fully first. if you are in doubt of it Iwouldnt do DB drags.
power issues will cost you gear. ( when it blows up.)
0
Someone Help
Started by [TUFEA-6], Mar 02 2005 07:15 PM
17 replies to this topic
#17
-
- Members
- 25 posts
25 - 250w RMS
Posted 02 March 2005 - 08:21 PM
hahaha yeah i will get it sorted b4 i go db draging it
can somebody explain to me how dual voice coil subs should be or can be hooked up to perform best (keep in mind i know nothing)
can somebody explain to me how dual voice coil subs should be or can be hooked up to perform best (keep in mind i know nothing)
#18
-
- Members
- 404 posts
25 - 250w RMS
Posted 02 March 2005 - 08:47 PM
It depends on what VC configuration you have, how many subs and what load your amp can support. Ultimately the VC configuration is purely a means to put the best load on your amp to run your subs
eg: a amp can usally has higher RMS rating at 2ohm compared to 4ohm. So you configure the VC's in a way that will allow them to reach a 2ohm load either be it by series or parrallel wirring the subs.
Since I don't know the specs of your equipment, I cant exactly tell you how to wire anything up at this stage but one of the other guys will know the specs of your gear....or you could list them.
eg: a amp can usally has higher RMS rating at 2ohm compared to 4ohm. So you configure the VC's in a way that will allow them to reach a 2ohm load either be it by series or parrallel wirring the subs.
Since I don't know the specs of your equipment, I cant exactly tell you how to wire anything up at this stage but one of the other guys will know the specs of your gear....or you could list them.
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
Community Forum Software by IP.Board
Licensed to: Mobile Electronics Australia
