My JL Amps are screwed to the metal seat backs.
works fine.
depends on the amps if they are isolated or common ground.
you can check with an ohm meter, if there's any connection from the chassis of the amplifier to any electrical connections of the terminals.
if the reading changes from "open circuit" to any other value, then you may have a problem.
0
grounding chassis of amp to chassis of car - noise?
Started by broadz, Dec 14 2011 09:49 AM
amplifier chassis ground
15 replies to this topic
#16
-
- Verified Trader
-
- 11,176 posts
Digital is only on or off
- Gender:Male
- Location:Melbourne, VIC
- Interests:Audio, Computers, Mobile Electronics
- State:VIC
Posted 17 December 2011 - 06:52 AM
http://www.melbourneaudioclub.org.au
http://www.aes.org
MEASQ 2008 National Judges' Choice
MEASQ 2009 Victorian Runner Up - Expert Class, National Champion - Expert Class
dB Drag 2008 Street A: 147.2dB @ 46Hz
VK3TUG - Life's too short to QRP
Note to self: Install more gear.
TEAM Floor-Pods
http://www.aes.org
MEASQ 2008 National Judges' Choice
MEASQ 2009 Victorian Runner Up - Expert Class, National Champion - Expert Class
dB Drag 2008 Street A: 147.2dB @ 46Hz
VK3TUG - Life's too short to QRP
~Spyne~, on 15 July 2009 - 07:33 PM, said:
gear = wank unless it's installed
TEAM Floor-Pods
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users
Community Forum Software by IP.Board
Licensed to: Mobile Electronics Australia
