5 replies to this topic

[Daz]

ok i'm running a Fusion DA monoblock and think i have wired up the 2 x 12" DVC 2 ohm subs to .5 ohm can someone please advise me. as i was aiming for 1.0 ohm?

this is what i've done: i have wired each sub in paralel then hooked them to the amp as the amp has 2 pairs of terminals i have wired each to its own pair of terminals on the amp?

hope you understand what i mean as i normally run 1 amp per sub so i'm out of my comfort zone here. doh


cheers
Daz

[BigAnt]

http://www.jlaudio.c...+Drivers/656176

Taken from Tiger in another thread. Hope this helps.

[Tiger]

Daz, on 28 January 2012 - 10:39 AM, said:

ok i'm running a Fusion DA monoblock and think i have wired up the 2 x 12" DVC 2 ohm subs to .5 ohm can someone please advise me. as i was aiming for 1.0 ohm?

this is what i've done: i have wired each sub in paralel then hooked them to the amp as the amp has 2 pairs of terminals i have wired each to its own pair of terminals on the amp?

hope you understand what i mean as i normally run 1 amp per sub so i'm out of my comfort zone here. doh


cheers
Daz

Yeah, with dual 2s, you're either gonna get 2ohm onseries and 0.5ohm parallel mode. You need 2 x dual 4 for a 1ohm setup UNLESS, you wanna run a single dual 2... you'll get your 1ohm load in parallel... just means you need double the amps :/

BigAnt, on 28 January 2012 - 11:59 AM, said:

http://www.jlaudio.c...+Drivers/656176

Taken from Tiger in another thread. Hope this helps.

I thought that looked familiar haha. Cheers for bringing that up... it's a good source to go off

[Daz]

thanks guys that has got me sorted so i'll run @ 2 ohms cool, thanks again

[Mr. Drifter]

I always use the rockford website if in doubt
http://www.rockfordf...ofer_wizard.asp

but either will do xD

[Daz]

done and is running right now thanks